![]() calibrate_linear: #setting the voltage values to equalent percantagesĬondition: #check that the threshold value from HA UI is importedĬondition: #compare value from sensor with thresholdvalue For this i added a condition to check for this value. I used your idea but at the end i figured it out that there was an issue to update the threshold value from HA. ![]() I just wanted to show my current status.Įntity_id: input_sired_moisture1Įntity_id: input_sired_sleeptime1 Becaus of this there are so many status LEDs and logging code. I still trying to figuring it out where the problem is. Lambda: 'return id(moisturesensor).state < id(moisture_set).state ' Lambda: 'return id(moisturesensor).state 0.00 I modified it and now i have a solution witch is also still triggering if the value doesnt change the range and it is also in deep_sleep after pumping. It didnt worked perfectly because it had still the issue that if the Sensor value was still in the same range it didnt triggered the condition e.g. It will water for 5s and wait for a minute, then water again for 5s in a loop until the sensor is above 50, then go back to the sleep routine. If when it comes out of sleep and the sensor is below 50 it will suspend sleep. if no pumping needed go back for longer deep sleepĭeep sleep runs in a loop, you’ll need to set an interval to check, below it’s 6 hours.if under threshold pump and go in short deep sleep.Check if pumping is forced, if yes pump and go to short deep sleep.Otherwiese i would like to get help in how to make some kind of loop that ist doing something like this: ![]() So if you provide a link to this topic it would be a big help. I can imagine that someone had the same idea and its already solved but i didnt find it. # Enable fallback hotspot (captive portal) in case wifi connection fails platform: adc # airdry: 2,8V waterwet: 1,58V My current code in ESPHome is this: esphome: Just with the difference that i use an esp32 instead of an esp8266.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |